Cloning cylinder, PS, sterile
These cloning cylinders facilitate the isolation of individual cell clones, each generated from a single cell, yielding a homogenous population of cells. To isolate a clone, a thin layer of grease is applied to the bottom edge of the cylinder and then inverted over the clone of choice. After adding a small volume of Trypsin or EDTA, the dish is incubated at 37 ºC (98.6 ºF) briefly until cells detach. Cells are then collected from inside the cylinder and transferred to another vessel for further growth.
-Cylinders are tapered so bottom edge is wider than the top ensuring a good sealing surface
-Polystyrene cloning cylinders are supplied in sterile packs
-Three sizes: 4.7 mm I.D. x 8 mm H, 6.4 mm I.D. x 8 mm H and 9.5 mm I.D. x 11 mm H
-Packed 10 per bag, one size
Tuotekoodi | Valmistaja | Nimi | Type |
---|---|---|---|
6267086 | F37847-0200 Bel-Art Products |
Cloning Cylinder, PS 50 |
Cloning Cylinders: 6.4 mm I.D. x 8 mm H |
6270364 | H37847-0000 Bel-Art Products |
BEL-ART-Cloning cylinder, PS 120 |
Assorted Cloning Cylinders: 4.7 mm I.D. x 8 mm H, 6.4 mm I.D. x 8 mm H and 9.5 mm I.D. x 11 mm H, 40 of each size |
6270365 | F37847-0100 Bel-Art Products |
BEL-ART-Cloning cylinder, PS 50 |
Cloning Cylinders: 4.7 mm I.D. x 8 mm H |
6270371 | F37847-0300 Bel-Art Products |
BEL-ART Cloning cylinder, PS 50 |
Cloning Cylinders: 9.5 mm I.D. x 11 mm H |
Mäkituvantie 7, 01510 Vantaa
Puhelin 0207413170
Fax 0207413189
Sähköposti Tämä sähköpostiosoite on suojattu spamboteilta. Tarvitset JavaScript-tuen nähdäksesi sen.
Sähköposti:
Tämä sähköpostiosoite on suojattu spamboteilta. Tarvitset JavaScript-tuen nähdäksesi sen.
Henkilökohtaiset sähköpostiosoitteet:
Tämä sähköpostiosoite on suojattu spamboteilta. Tarvitset JavaScript-tuen nähdäksesi sen.
Asiakaspalvelu
Tilaukset ja ostot
Puhelin 0207413170